Essential Key Operator
Duties Typically include:
- Draining the boiling tank.
- Operating the Solid State features
- Becoming familiar with service
procedures
Solid State Controls
innowave incorporated has developed
a programmable Solid State LCD display to assist the Key Operator
in the periodic maintenance of the unit. One of the main functions
of this LCD display is to inform the Key Operator when the
boiling tank requires draining. Other key functions of the
display include displaying time, hours run, remaining drain
cycle time, and a manual start/stop function. The LCD display
may also display a fault code. Fault codes are typically service
messages designed to inform your local innowave Dealer of
scheduled maintenance to the unit such as softener replacement.
Setting Day and Time
The innowave 270™ continuously
displays the day and time, unless the Key Operator activates
the key pad to read additional information. To change the
day and time, press either the up or down arrow on the keypad
until "Set Time" is displayed. The display should look like
this:
To program the day and time,
press the right arrow. The display will show the day with
an underline under the first letter in the day. An example
will look like this:
To change the day, press the
keypad's up or down arrow until the desired day is displayed.
Once the desired day is displayed, press the right arrow.
After pressing the arrow to the right the hours in the time
portion of the "Set" display will be underlined. An example
will look like this:
To change the hours, press
the up or down arrow until the desired hour is displayed.
Repeat the process to set the minutes and AM or PM (A=AM and
P=PM). The display will look like this
Once the desired day and time is displayed press the right
arrow. This will set the day and time into the unit. An example
of the display should now look like this:
Hours Run
To determine how many hours the innowave 270™ has run,
press the up or down arrow until the "Hours Run" display is
shown. The display should look like this:
Where "xxxxx" is the number
of hours the unit has run.
Manual Start/Stop
To manually start or stop the
innowave 270™, press the up or down arrow until the display
shows either:
or
If the display shows "Manual
Start", pressing the right arrow will start the unit. If the
display shows "Manual Stop", pressing the right arrow will
stop the unit.
Service Detection
In the unlikely event of an
error during operation, the unit will shut down. The display
will show the message:
These displays will be shown on a rotating basis (where "Ph
xxx-xxx-xxxx" is the service phone number to call and "Fault
xx" is the error number that has occurred). If you receive
this type of message, contact your local innowave Dealer.
Emergency
Procedures
As with many other appliances
and equipment in your office, it is always a good idea to
become familiar with what to do in case of an emergency. You
should know:
-
How to manually start
and stop the machine (see Manual START/STOP).
-
How to turn off electricity
to the machine (how to unplug).
-
How to manually shut
off water to the machine (locate shut-off valve).
270
Troubleshooting Guide
|
